Instruction manual

Prosilica GX Technical Manual V2.2.0

Camera interfaces

Gigabit Ethernet port

The Gigabit Ethernet port conforms to the IEEE 802.3 1000BASE-T standard for

Gigabit Ethernet over copper. Allied Vision recommends using Category 6 or

higher compatible cabling and connectors for best performance.

The Prosilica GX offers two Gigabit Ethernet ports. This interface is enabled

using Link aggregation. A link aggregation group (LAG) is automatically config-

ured on the camera when both ports are connected. The host computer requires

a dual port, LAG capable Ethernet adapter. The LAG group needs to be config-

ured by the user.

www



The GigE Installation Manual offers detailed instructions for

using Prosilica GX cameras in a dual port configuration.

http://www.alliedvision.com/fileadmin/content/documents/

products/cameras/various/installation-manual/

GigE_Installation_Manual.pdf

Note



See Hardware Selection for Allied Vision GigE Cameras appli-

cation note for a list of recommended Ethernet adapters:

http://www.alliedvision.com/fileadmin/content/documents/

products/cameras/various/appnote/

Hardware_Selection_for_Allied_Vision_GigE_Cameras.pdf

A standard Ethernet adapter is available for purchase from

Allied Vision:

P/N: 02-3002A

Model: Intel Pro 1000/PT

Note



Cable lengths up to 100 m are supported.

The 8-pin RJ-45 jack has the pin assignment according to the

Ethernet standard (IEEE 802.3 1000BASE-T).

Note



Prosilica GX cameras support cables with vertical locking screw

connector for a secured connection (See figure 27).

Allied Vision recommends using locking-screw cables from

Components Express, Inc. for a perfect fit. Visit the CEI product

configurator to customize the cable according to your needs.