Installation manual

AVT GigE Cameras Installation Manual V1.0.1
44
Implementing link aggregation
– Select team type: Static Link Aggregation
click Next
This configures the team and a new adapter appears in the Network Connections
window.
[Linux]
Link Aggregation is referred to as bonding in Linux. The following instructions
are for Ubuntu Linux 10.04 or newer.
– Download ifenslave module
– Terminal: sudo apt-get install
ifenslave
– Terminal: ifconfig
– Note eth#'s of NICs to be bonded
– Terminal:
sudo gedit /etc/network/interfaces
– Add/edit:
auto bond0
iface bond0 inet static
address 169.254.100.101
netmask 255.255.0.0
bond-slaves eth6 eth7
bond_mode 0
mtu 8228
where, eth6 and eth7 are the
NICs to be bonded.
Figure 35: Team wizard team type selection
Note

The newly formed team adapter can be managed
using automatic IP configuration or fixed IP using
instructions provided in Modify Ethernet adapter IP
address on page 17.
www

For full installation instructions on Ubuntu, see:
https://help.ubuntu.com/community/UbuntuBonding
https://help.ubuntu.com/community/LinkAggregation
Figure 36: Interfaces file for bonding