Installation manual

AVT GigE Cameras Installation Manual V1.0.1
41
Using multiple cameras
The following steps are required to configure a multiple Ethernet port camera
system:
• Fix host adapter IP address
• Fix camera IP address
Fix host adapter IP address
– Refer to Modify Ethernet adapter
IP address on page 17.
– Select Use the following IP
address:
Adapter1 IP Address: 169.254.100.1
Subnet mask: 255.255.255.0
Adapter2 IP Address: 169.254.200.1
Subnet mask: 255.255.255.0
Fix camera IP address
– Refer to Modifying camera IP
address on page 35.
– Set the following IP addresses:
Camera1 IP Address: 169.254.100.2
Subnet mask: 255.255.255.0
Adapter1 IP Address: 169.254.200.2
Subnet mask: 255.255.255.0
Note

The host can be configured using multiple single
port adapter cards, multiple dual port, quad port
and so on. The same IP addressing model can be
scaled to larger network configurations.
Figure 30: IP configuration window for
Adapter 1
Figure 31: AVT IPConfig camera IP address
configuration window