Specifications

Camera interfaces
Bigeye Technical Manual V2.0.0
39
Beside the internal exposure control capabilities also direct exposure control
by an externally applied signal is possible. In this case the ExposureMode has
to be configured to Off to deactivate the internal timer.
Mode setting
The GigE Vision feature AcquisitionControl/TriggerMode setting provides a
method for switching the camera between different exposure control modes.
The individual function depends on the camera variant.
The Mode input (Pin 9) can be used to control this setting using an external sig-
nal.
Note

Bigeye P-629: The timer has to be enabled via the
ExposureMode feature in order to control the exposure. Set the
TriggerMode feature to On if the electromechanical shutter
operation is needed, otherwise it will stay permanently open.
Note

For more information see Chapter Mode input (Pin 9) on page
32.
Note

The active state (externally low at pin 9 or TriggerMode = On) is
dominant, thus image-on-demand is active if one of either set-
tings is.
Camera TriggerMode Description
Bigeye P-132B On Image-on-demand mode.
Exposure control via ExposureTime and DarkTime features
(ExposureMode = Timed) or externally (ExposureMode = Off).
Off Continuous mode with fixed exposure time and frame rate.
Bigeye P-132x Cool On Image-on-demand mode.
Peltier cooling active.
Exposure control via ExposureTime and DarkTime features
(ExposureMode = Timed) or externally (ExposureMode = Off).
Off Continuous mode with fixed exposure time and frame rate.
Peltier cooling inactive (power saving).
Table 13: TriggerMode