Specifications

Camera interfaces
Bigeye Technical Manual V2.0.0
31
This jack is intended for the power supply as well as for controlling the camera
by the user.
Power supply (Pin 1-4)
Bigeye P-132 The camera requires 12 V +5% at a current capacity of maximum 0.8 A.
After attaining the end cooling temperature (- 20 °C) the current capacity goes
down to approx. 1.9 ... 2.3 A. The exact value also depends on the ambient tem-
perature of the camera (not for Bigeye P-132B, because it is uncooled).
Bigeye P-629 The camera requires 12 V +5% at a current capacity of maximum 2.8 A.
After attaining the end cooling temperature (- 20 °C) the current capacity goes
down to approx. 1.3 ... 1.7 A. The exact value also depends on the ambient tem-
perature of the camera.
Bigeye P-1100 The camera requires 12 V +5% at a current capacity of maximum 3.0 A.
Figure 13: Camera I/O connector pin assignment (Bigeye P-1100B/C Cool)
Bigeye P-1100B Cool / P-1100C Cool
Pin Signal Direction Level Description
1
External Power +12 V DC
Power supply
max. 3.0 A
2
3
External GND
4
5 --- Reserved
6 --- Reserved
7 RXD In RS232 Serial control
8 TXD Out RS232 Serial control
9 Mode input + 12V, 20 mA max. Internal pull-up resistor
10
Trigger input
-
12V, 20 mA max. Optocoupler input
11 +
12
Exposure output
-
12V, 20 mA max. Optocoupler output
13 +
14 Line-sync output Out 5 V (at no load) Active low
15 Frame-sync
output
Out 5 V (at no load) Active low