Specifications

Camera interfaces
Bigeye Technical Manual V2.0.0
29
Camera interfaces
This chapter gives you information on the control junction, inputs and outputs
and trigger features.
Control junction
Camera I/O connector pin assignment (15-pin
D-Sub jack)
This jack is intended for the power supply as well as for controlling the camera
by the user.
www

For accessories like cables see:
http://www.alliedvisiontec.com/emea/products/
accessories/gige-accessories.html
Figure 11: Camera I/O connector pin assignment (Bigeye P-132B/Cool/Solar Cool)
Bigeye P-132B / P-132B Cool / P-132B Solar Cool
Pin Signal Direction Level Description
1
External Power +12 V DC
Power supply
max. 2.8 A
2
3
External GND
4
5 --- Reserved
6 --- Reserved
7 RXD In RS232 Serial control
8 TXD Out RS232 Serial control
9 Mode input + 12V, 20 mA max. Internal pull-up resistor
10
Trigger input
-
12V, 20 mA max. Optocoupler input
11 +
12
Exposure output
-
12V, 20 mA max. Optocoupler output
13 +
14 Line-sync output Out 5 V (at no load) Active low
15 Frame-sync
output
Out 5 V (at no load) Active low