Technical information

AVT GigE camera and driver features
AVT GigE Camera and Drivers Features V2.0.0
18
This document is a master document for all AVT GigE camera models and is NOT camera specific
Controls
BlackLevelControl
BlackLevel [Float] R/W
Black level value. Setting the Gain does not change the BlackLevel.
BlackLevelSelector [Enum] R/W
Selects which black level is controlled by the various black level features.
CCDTemperatureOK [Integer] R
Current temperature status of the CCD sensor. Momentary temperature status of
the CCD sensor. Indicates if CCD sensor has desired cooling temperature.
ColorTransformationControl
This section describes features related to color transformations in the AVT GigE
color cameras.
The following controls are only valid when using on-camera interpolated Pix-
elFormats .
Definition The color transformation is a linear operation taking as input the triplet R
in
,
G
in
, B
in
for an RGB color pixel. This triplet is multiplied by a 3x3 matrix.This
color transformation allows to change the coefficients of the 3x3 matrix.
ColorTransformationMode [Enum] R/W
Selects the mode for the color transformation.
Range: [0–255.75] Default: 0
Possible values: All
0 [Default] The CCD sensor may be too hot. Acquired image
data may have higher noise than expected or contain
erroneous pixels at long exposure times
1 The CCD sensor temperature is in the desired temperature
range. Acquired image data are OK
Off [Default] No color transformation
Manual Manually set ColorTransformationValue matrix
coefficients
Temp6500K Colors optimized for a surrounding color temperature 6500 K
R
out
G
out
B
out
Gain00 Gain01 Gain02
Gain10 Gain11 Gain12
Gain20 Gain21 Gain22
x
R
in
G
in
B
in
=