Installation manual

TurboStack Hubs with Management

5. Separate the AUI appliqué connector plate (shown in Figure 15) from

the ribbon cable (shown in Figure 16) by rotating the cable 90° and

sliding it through the slot in the connector plate.

6. Store the detached AUI appliqué plate, slide kit screws, washers, and

nuts in a secure container for future use.

To install a 10BASE2, 10BASE-T or fiber Optic (10BASE-FL)

appliqué

1. Remove the AUI appliqué (as described above).

2. Plug the replacement 10BASE2, 10BASE-T, or 10BASE-FL appliqué

into the AUI connector, as shown in Figure 17.

Figure 16: AUI Connector and

Ribbon Cable

Assembly

Figure 17: Appliqué

Installation

AUI

connector

Ribbon cable

without

connector plate

Replacement

cover plate

AUI connector

Replacement

appliqué