User manual

AT-TSAx Appliqués
3
Location of Appliqué Port
In a TurboStack department concentrator chassis, manageable hubs can be
connected to network zones using different cable media by installing different
appliqués.
To install or remove an appliqué, find the TurboStack hub appliqué port. As shown
in Figure 2, this port is located directly to the left of the RS232 terminal port on the
module faceplate (in this case an AT-TS06F/SC model hub).
Figure 2: AT-TS06F/SC Faceplate
The appliqué port is convertible on all TurboStack hubs with management. You
may configure it by installing an alternative to the AUI network-interface appliqué
as described below.
Network LEDs
Appliqué port (configured as AUI)
SC port connectors
Power receptacle
RS232 port