Installation manual

Overview
2
Turbo Stack AT-TS90TR Switch
Your AT-TS90TR incorporates:
❑ 100 Mbps of dedicated bandwidth for each of the two 100BASE-TX
ports
❑ MII port is auto-sensing providing either half or full duplex
transmission
❑ 10 Mbps of dedicated bandwidth for each of the eight 10BASE-T
ports
❑ Complete error checking functionality
❑ 48-bit IEEE 802 MAC addressing
❑ Spanning Tree Protocol (802.1d) implementation
❑ MIB II and Bridge MIB compliance
❑ Recessed reset switch
❑ Either standalone, 19-inch rack mount, or Turbo Stack chassis
mounting
❑
Comprehensive diagnostic LED support
❑ 2048 Media Access Control (MAC) address storage
❑ Two modes of switching functionality:
— Cut-through
— Full store-and-forward
❑ Telnet, BOOTP, and TFTP software support
Your AT-TS90TR also offers features that can help you manage and
maintain your network including:
❑ An optional, extra cost, firmware cassette (AT-S6) for upgrading
software and password
❑ Optional, extra cost, AT View network management software
❑ Included either in-band or out-of-band management through a
Telnet virtual terminal connected to the RS232C port
Figure 1: AT-TS90TR Ethernet
Switch with Fast Ethernet Access