Specifications

Hardware Installation

Note

If you have configured your chassis with both AT-3600 Series modules and

TurboStack modules, you will need to refer to the AT-3600 Series Hub/

Repeaters and AT-S4 Firmware Module Network Operations Manual. The

AT-S10 software will not run on a chassis configuration that includes both

AT-3600 and TurboStack modules. See your ATI sales representative for

further details.

Attention

If a fault light illuminates and/or the port activity (link) LEDs on the

Master module illuminate when you first power up a hub, there may be a

problem with the unit. The recommended sequence of corrective steps is as

follows: 1) turn off the power and power up a second time; 2) insert a

firmware cassette in the back-panel port of the unit; 3) initiate a Return

Material Authorization (RMA) to ATI.

For a detailed explanation of ATI’s TurboStack chassis offerings, refer to

the TurboStack™ Chassis and Backplane Installation Manual, available

through your local ATI sales representative.

TurboStack Port Configurations

Network Ports TurboStack hub models feature a variety of port counts and support a

variety of media, including:

❑ Fiber optic (10BASE-FL), using SM, SC or ST connectors

❑ Thinnet (10BASE2), using BNC connectors

❑ UTP/STP (10BASE-T), using Telco RJ21 or RJ45 connectors

❑ Thick Ethernet (10BASE5), using the AUI connector

RS232 Terminal Port Every TurboStack hub with management capability includes an RS232

Terminal Port on the faceplate. (See Figure 10.)

Figure 10: RS232 Terminal

Port

RS232 port

Appliqué port

(conﬁgured as AUI)

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com