Specifications

Hardware Reference 49
C613-03058-00 REV A
combinations of the following PICs (with a maximum of two E1/T1/PRI
cards):
■
AT-AR020 PRI E1/T1 PIC, one Primary Rate E1/T1 port.
■
AT-AR021(S) BRI-S/T PIC, one Basic Rate ISDN S/T port.
■
AT-AR021(U) BRI-U PIC, one Basic Rate ISDN U port.
■
AT-AR023 SYN PIC, one Synchronous port with universal 50-way
AMPLIMITE connector.
■
AT-AR024 ASYN4 PIC, four Asynchronous ports with RJ-45 connectors.
AT-AR022 ETH PICs and AT-AR026 4ETH PICs are not recommended for use in the
NSM PIC bays, as performance of these interfaces is likely to be reduced and packet loss
may occur.
AT-AR745 routers have a dedicated PAC slot. PAC slots can accommodate the
following PACs:
■
AT-AR060 EPAC, Encryption PAC.
■
AT-AR061 ECPAC, Compression/Encryption PAC.
PACs should only be installed by authorised service personnel. Unauthorised
opening of the router lid may cause danger of injury from electric shock, damage
to the router, and invalidation of the product warranty.
Front and Rear Panels
Front and rear panels of the AT-AR745 router with a PIC installed in each PIC
bay, and an AT-AR040 4-PIC NSM installed in the NSM bay, are shown in
Figure 21 on page 49.
Figure21: Front and rear panels of the AT-AR745 Series router.
SYN
Tx
Rx
SYN
Tx
Rx
ASYN
30
Data
ETH
Link
Data
ETH
Link
ASYN
30
3
1
2
0
Asynchronous
ports
Power switch
AC Power inlet
MAC engine
and Base LEDs
NSM Bay with AT-AR040 4-PIC NSM and PICs installed
NSM Hot
Swap button
and LEDs
Ethernet Ports
and LEDs
745FRP
LEDs
Two PIC bays with PICs installed
DC Power inlet for RPS
Rear Panel
Front Panel
Compact Flash
AC POWE R
100-240 VAC
50-60 Hz
1.0 A
5V/5.5A
12V/1.0A
-12V/0.1A
RPS DC POWER
L/A L/A
SWAPNSM 0
HOT
SWAP
IN 100M
ETHERNET 1
ENGINE
ACT
PWR
DAT
RUN
ER
SYS
CLR
SEC
PORT 1 PORT 0
PIC 0
BASE
PIC 1
PIC 0
100M
PIC 1
ETHERNET 0
DISCONNECT POWER BEFORE INSTALLING/REMOVING PIC
STATUS
SECURITYPOWER RUN SYSTEM CLEAR
AR745
Modular Enterprise Router
ACTIVITY
COMPACT FLASH