Specifications

48 AR Router
C613-03058-00 REV A
Redundant Power Supply (RPS)
AC models of the AT-AR740 can be used in conjunction with the AT-RPS 740.
Each AT-RPS 740 can provide power supply and mains circuit redundancy for
up to two AT-AR740s. For more information on the AT-RPS 740, see “AT-RPS
740” on page 54.
For connection to an AT-RPS 740, the AT-AR740 Router has a female DB25
connector on its rear panel (Figure 20 on page 48). Pin outs for the connector
are listed in Table 21 on page 48.
Figure20: DB25 female connector pinout for an RPS on the AT-AR740 rear panel
AR745 Router
The AT-AR745 router consists of a base CPU card, enclosure, and power
supply. The base CPU card supports two 10/100 autosensing Ethernet LAN
ports and two asynchronous RS-232 ports.
AT-AR745s have a Network Service Module (NSM) bay and two Port Interface
Card (PIC) bays. The NSM bay is PCI based to provide support for a number of
higher density or higher performance interfaces.
NSMs with fixed ports are available (e.g., AT-AR041 and AT-AR042 BRI S/T
NSMs) as are NSMs with PIC bays (e.g., AT-AR040 4 PIC NSM) for flexible
expansion options. The PIC bays and the 4-PIC NSM can accommodate
Table 21: DB25 RPS power connector pin out on the AT-AR74 0 .
Pin Function Direction
1, 25 Keying -
2, 14 +12V input
3-5, 15-17 +5V input
6-8, 18-20 0V input
9 -12V input
10 VCC output
11 Main PSU error output
12 Main fan error output
13 RPS disconnected input
21 Sense 0V output
22 Sense +5V output
23 RPS PSU error output
24 RPS fan error input
Pin 25
Pin 14
Pin 13
Pin 1
A740db25