Specifications
Table Of Contents
- AR Router Hardware Reference
- Copyright
- Contents
- Introduction
- Models Covered By This Reference
- Where To Find More Information
- Using Windows Terminal and Windows Hyperterminal
- Router Start-up
- Online Documentation
- AT-TFTP Server
- Memory
- AR300 Series Routers
- AR400 Series Routers
- AR700 Series Routers
- AT-RPS 740
- Mini Accelerator Cards (MACs)
- PCI Accelerator Cards (PACs)
- Flash Memory
- Interfaces
- Test Facility
- Cables And Loopback Plugs
- PICs and NSMs
- Restricted Procedures
- Contacting Us

44 AR Router
C613-03058-00 REV A
PAC slots can accommodate the following PACs:
■
AT-AR060 EPAC, Encryption PAC.
■
AT-AR061 ECPAC, Compression/Encryption PAC.
PACs should only be installed by authorised service personnel. Unauthorised
opening of the router lid may cause danger of injury from electric shock, damage
to the router, and invalidation of the product warranty.
Front and Rear Panels
Front and rear panels of the AT-AR740 router with a PIC installed in each PIC
bay, and an AT-AR040 4-PIC NSM installed in the NSM bay, are shown in
Figure 18 on page 44.
Figure18: Front and rear panels of the AT-AR740 Series router.
LEDs and what they mean
Functions of the AR740’s LEDs are shown in Table 20 on page 44. Additional
rear panel LEDs may be present if a PIC or NSM is installed. Functions of PIC
and NSM LEDs are described in their respective Hardware References.
SECURITYCLEARSYSTEMRUNPOWER
STATUS
Modular Branch Office Router
SYN
Tx
Rx
SYN
Tx
Rx
ASYN
30
Data
ETH
Link
Data
ETH
Link
ASYN
30
NSM 0
10 010 0
In Use
LNK
/ACT
LNK
/ACT
Port 0Port 1
Ethernet 0Ethernet 1
BASE
ENGINE
SECSYSRUNPWR
CLRERRDATACT
DISCONNECT POWER BEFORE INSTALLING/REMOVING PIC PIC 0PIC 1
Hot
Swap
Swap
AC Power
100-240 VAC
50-60 Hz
1.0 A
RPS
Power
3
1
2
0
Asynchronous
ports
Power switch
AC Power inlet
Base LEDSs and
MAC engine LEDs
NSM Bay with AT-AR040 4 PIC NSM and PICs installed
NSM Hot
Swap button
and LEDs
Ethernet Ports
and LEDs
740frac
Base LEDs
Two PIC bays with PICs installed
DC Power inlet for RPS
Rear Panel
Front Panel
Table 20: Functions of AT-AR740 router LEDs.
LED Function
Front panel Rear panel
ETH
These LEDs give indications about the Ethernet interfaces.
LNK/ACT Lit green when the Ethernet interface is connected to a device (e.g., a hub) which is
generating link pulses. Lit yellow indicates transmission or reception activity.
100M Lit when the Ethernet interface is in 100 Mbps mode.
BASE
These LEDs indicate the state of the main router unit.