Specifications
Table Of Contents
- AR Router Hardware Reference
- Copyright
- Contents
- Introduction
- Models Covered By This Reference
- Where To Find More Information
- Using Windows Terminal and Windows Hyperterminal
- Router Start-up
- Online Documentation
- AT-TFTP Server
- Memory
- AR300 Series Routers
- AR400 Series Routers
- AR700 Series Routers
- AT-RPS 740
- Mini Accelerator Cards (MACs)
- PCI Accelerator Cards (PACs)
- Flash Memory
- Interfaces
- Test Facility
- Cables And Loopback Plugs
- PICs and NSMs
- Restricted Procedures
- Contacting Us

36 AR Router
C613-03058-00 REV A
The Main System
Main features of AT-AR410 and AR410S routers are:
■
66 MHz RISC processor.
■
16 MBytes of synchronous DRAM.
■
8 MBytes of flash memory (1 MByte reserved for boot code).
■
4 x 10/100 Mbps full duplex Ethernet LAN ports.
■
1 x 10/100 Mbps full duplex Ethernet WAN port.
■
1 RS-232 asynchronous serial port (maximum speed 115200 bps).
■
1 PIC bay.
■
1 MAC slot for a MAC compression/encryption card (an AT-AR011V2
MAC card is factory fitted in the AR410S router).
■
Universal AC power supply.
Table 16: AR410 and AR410S System LEDs
LED State Function
Power Green The router is receiving power and the power
switch is in the ON position
System Amber The Router is malfunctioning
Off Normal operation
Enabled
(PIC Bay 0)
Green A PIC card is correctly installed and has been
detected by the router
Off No card is installed
Full
Green The corresponding port is operating at full-
duplex
Off The corresponding port is operating at half-
duplex
Link/ACT
Green A link has been established through the
corresponding port
Flashing Data is being transmitted through the
corresponding port
Off No link is present through the corresponding
port
100M
Green The corresponding port is operating at
100Mbps
Off The corresponding port is operating at 10Mbps