User`s manual

Chapter 1 - Using the AT-VP504E FXS User’s Manual (SIP/MGCP Version)
AT-VP504E FXS 12
X To check if the call forward has been properly established:
1. Take the receiver off-hook.
2. Wait for the dial tone.
3. Dial your extension or phone number.
The call is forwarded to the desired phone number.
4. Hang up your phone.
X To cancel the call forward:
1. Take the receiver off-hook.
2. Wait for the dial tone.
3. Dial *26.
4. Wait for the transfer tone (three “beeps”) followed by the dial
tone.
The call forward is cancelled.
5. Hang up your phone.
Call Forward
on Busy / No
Answer
You can automatically forward incoming calls
7
to a pre-determined
extension within your system if you do not answer before a specific
number of rings or if you are already on the line.
Note: The “*26” sequence can be user-configured. Check with your
system administrator for the exact sequence actually implemented.
7. Only valid for units that run the SIP signalling protocol.
Note: The call forward on busy / no answer can only be set up by your
system administrator. See your system administrator for more
information.