Specifications

Chapter 18 - sipUAGroup Parameters MIB Reference Manual - SIP MIB
VP500 Communication Unit 63
sipUAnAuth-
Group
sipUAAuthGroup The following parameters allow you to set parameters for the all of the
SIP User Agents
sipUAnFriendlyName R/W Friendly name for SIP User Agent #n.
Default Value: Port 1
Yes
sipUAnOtherAliases R/W Semi-colon separated list of other aliases for SIP User Agent #n.
An alias is either a user name or a telephone number.
Default Value:
Yes
sipUAnMustUseSessionTimers R/W Select if the session timer must be used.
0 = Don't use session timer.
1 = Must use session timer.
Default Value: 0
Yes
sipUAnMaximumSessionExpirationDelay R/W Set the maximun session expiration delay in seconds. If
sipUAnMustUseSessionTimers is set to 1, then an INVITE is sent
every n seconds, where n is specified in the
sipUAnMaximumSessionExpirationDelay variable. If an INVITE
does not get an answer, then the call is terminated. This option
allows to detect the end of a call caused by a communication
problem on the network. If sipUAnMustUseSessionTimers is set
to 0 and the network is cut off between the two telephones, then it
will not be possible to detect the end of the call, because no end
of communication packet will be received.
Default Value: 60
Yes
Table 74: sipUAn Group Parameters (Continued)
Name Acccess Description Dynamic
Table 75: sipUAn AuthGroup Parameters
Name Acccess Description Dynamic
sipUAnAuthUsrPwd R/W Username and password used for authentication. This value is
used only by this port.
Default Value:
Yes
sipUAnAuthValid R-O This value is set to:
1 = Value sipUAxAuthUsrPwd is valid.
0 = Value sipUAxAuthUsrPwd has a syntax error.
Default Value:
N/A
Table 76: sipUA AuthGroup Parameters
Name Acccess Description Dynamic
sipUAAuthUsrPwd R/W Username and password used for authentication. This value is
used by all ports.
Default Value:
Yes