Specifications
Table Of Contents
- MIB Structure
- InterfaceGroup Parameters
- apaManager Parameters
- apaUIGroup Parameters
- gatewayGroup Parameters
- countryGroup Parameters
- portGroup Parameters
- syslogGroup Parameters
- tftpGroup Parameters
- apaByPassGroup Parameters
- apaSystemGroup Parameters
- apaCmdGroup Parameters
- snmpGroup Parameters
- apaInfoGroup Parameters
- configTrapGroup Parameters
- sntpGroup Parameters
- mgcpConfiguration Parameters
- sipUAGroup Parameters
- List of MIB Parameters

VP500 Communication Unit 59
18
sipUAGroup Parameters
The sipUA Group parameters allow you to set information exclusive to
VP500 communication units that run the Session Initiation Protocol
(SIP).
Introduction The SIP MIB is used with VP500 communication units that run the
Session Initiation Protocol (SIP).
X To use the SIP MIB
In the general Provisioning MIB, locate the
signalingProtocolsSwitch variable under the
signalingProtocolsGroup.
This variable allows you to switch from one protocol to
another.
Set the signalingProtocolsSwitch variable to 1=SIP.
Reboot the VP500 communication unit.
After the VP500 communication unit restarts, it will use the
SIP MIB.
sipUA Basic
Parameters
The following parameters allow you to define basic SIP User Agents
information.
Table 66: SIP MIB Version Parameter
Name Access Description Dynamic
sipMibVersion R-O MIB version.
Default Value: 1.0
N/A
Table 67: sipUA Group Parameters
Name Access Description Dynamic
sipUAPort R/W SIP User Agent IP port number.
Default Value: 5060
Yes
sipUAProtocoleVersion R-O SIP stack protocol version.
Default Value: 2.0
N/A
sipUAServiceOperStatus R-O Not implemented ... for future use only. N/A
sipUAServiceAdminStatus R-O Not implemented ... for future use only. N/A
sipUAServiceStartTime R-O Not implemented ... for future use only. N/A