Specifications

Table Of Contents
VP500 Communication Unit 45
16
sntpGroup Parameters
This chapter describes the SNTP settings that can be set on the VP500
communication unit.
General Parame-
ters
The general SNTP parameters allow you to enable and synchronize
the SNTP feature.
sntpStaticGroup
Parameters
The following parameters allow you to set static SNTP information for
the VP500 communication unit
Table 50: SNTP General Parameters
Name Access Description Dynamic
sntpEnable R/W Enable SNTP Client.
0 = Disable
1 = Enable
Default Value: 0
Yes
sntpSynchronizationPeriod R/W Interval in minutes before sending a SNTP time request to the
SNTP server. Values range from 2 to 1440 seconds.
Default Value: 1440
Yes
sntpSynchronizationPeriodOnError R/W Interval in minutes before sending a SNTP time request to the
SNTP server after an SNTP error. Values range from 1 to 60
minutes.
Default Value: 60
Yes
sntpUseDhcp R/W Select the provenance of the SNTP Server network configuration.
0 = Static
1 = Dhcp
Default Value: 0
Yes
a
a. Only when at least one of the variables xxUseDhcp was set to 1 before starting the VP500 unit.
Table 51: Static SNTP Parameters
Name Access Description Dynamic
sntpStaticHost R/W Static SNTP server IP address or domain name.
Default Value: 192.168.0.10
Yes
sntpStaticPort R/W Static SNTP server IP port number.
Default Value: 123
Yes