Specifications
Table Of Contents
- MIB Structure
- InterfaceGroup Parameters
- apaManager Parameters
- apaUIGroup Parameters
- gatewayGroup Parameters
- countryGroup Parameters
- portGroup Parameters
- syslogGroup Parameters
- tftpGroup Parameters
- apaByPassGroup Parameters
- apaSystemGroup Parameters
- apaCmdGroup Parameters
- snmpGroup Parameters
- apaInfoGroup Parameters
- configTrapGroup Parameters
- sntpGroup Parameters
- mgcpConfiguration Parameters
- sipUAGroup Parameters
- List of MIB Parameters
Chapter 7 - portGroup Parameters MIB Reference Manual - Provisioning MIB
VP500 Communication Unit 27
portnDspCodecG729ABGroup
portnDspCodecT38Group
portnDtmfGroup The following parameter allow you to set DTMF Transport type.
Table 33: DSP Codec G729AB Parameters
Name Access Description Dynamic
portnDspCodecG729ABEnable R/W Enable G.729.AB on Port #n.
0 = Disable
1 = Enable
Default Value: 1
Yes
portnDspCodecG729ABPTimeMin R/W Port #n minimum packetization time (ptime) for G.729.AB in ms.
WARNING: Valid values are 10, 20, 30, and 40. The default value
is used if the value is invalid.
Default Value: 10
Yes
portnDspCodecG729ABPTimeMax R/W Port #n maximun packetization time (ptime) for G.729.AB in ms.
WARNING: Valid values are 10, 20, 30, and 40. The default value
is used if the value is invalid.
Default Value: 10
Yes
Table 34: DSP Codec T.38 Parameter
Name Access Description Dynamic
portnDspCodecT38Enable R/W Enable T.38 on Port #n.
0 = Disable
1 = Enable
Default Value: 1
Yes
Table 35: DTMF Parameter
Name Access Description Dynamic
portnDtmfTransport R/W Attribute to select the type of DTMF transport.
0 = In band
1 = Out-of-Band using Signaling Protocol
2 = Out-of-Band using RTP DTMF payload
Default Value: 2
N/A