Specifications

VP500 Communication Unit 17
5
gatewayGroup Parameters
The gatewayGroup parameters allow you to set the various permission
settings used when making calls in gateway mode.
gatewayGroup
Basic Parameter
The following parameter allows you to define the General Dial Prefix to
use when making calls.
gateway-
PortnGroup
The following parameters allow you to set gateway information on Port
#n.
Note: The gatewayGroup parameters are used only by gateway units
such as the AT-VP504E FXO.
Table 16: Gateway Group Basic Parameter
Name Access Description Dynamic
gatewayGeneralDialPrefix R/W Prefix that must be dialed before any other numbers on a port
used in FXO mode.
Default Value:
Yes
Note: Each port of the VP500 communication unit has its own set of
parameters. The parameter description is identical for each port. For
clarity’s sake, only one generic set of parameters is described in this
manual. When browsing through the Provisioning MIB, replace the “n”
letter in the following parameters with the proper port number (from 1
to 4).
Table 17: Gateway Port n Parameters
Name Access Description Dynamic
gatewayPortnPermissionMode R/W Select port #n configuration used in FXO mode.
0 = Net to PSTN
1 = PSTN to Net
2 = Both directions
Default Value: 2
Yes