Specifications

AT-VP504E FXS 61
8
Unit Manager Configuration
The Unit Manager is a module of the IP Communication Server or the
Unit Manager Network product. Both are used to remotely configure
VP500 communication units. The Unit Manager is a graphical interface
that helps you work with the MIB variables involved in the
AT-VP504E FXS setup.
Using the Unit
Manager
You have the choice of setting up AT-VP504E FXS communication
units directly with a SNMP browser or use the Unit Manager to
remotely set up units.
To use the Unit Manager:
1. Locate the apaManagerEnable variable (under
apaManagerGroup ).
This variable enables the Unit Manager to remotely manage
the AT-VP504E FXS.
2. Set the apaManagerEnable variable to 1=Enable.
3. Set the Trap retransmission period to the desired value.
The default value is 60 seconds.
4. Set the Trap retransmission retry count to the desired value.
When the retry count is elapsed, the AT-VP504E FXS will
stop the provisioning sequence. The default value is 10.
If this variable is set to -1, then the provisioning sequence will
never be stopped. The trap will be sent until the Unit Manager
replies.
Note: For more information on how to use the Unit Manager to set up
AT-VP504E FXS communication units, please refer to the IP
Communication Server manual.