Specifications

Chapter 5 - Software Download Administration Manual (SIP/MGCP Version)
AT-VP504E FXS 47
3. Contact the AT-VP504E FXS with any SNMP MIB browser.
Be sure to use the MIB modules that match the version of the
MIBs located inside the current software build of the
AT-VP504E FXS.
4. Locate the tftpGroup category in the Provisioning MIB.
This category contains all the variables you must set to
properly download a software version. These variables
include:
• Binary file name to download
• Software server address where to get the binary
file
• Port number of the software server
This can be done statically through SNMP, automatically
through the Unit Manager, or dynamically through the DHCP
server.
5. If the DHCP server did not provide the information to the
AT-VP504E FXS, configure the
tftpServerStaticHost variable
in the
tftpGroup category with the current address of the PC
that runs the TFTP server.
For example, set the variable with a valid IP address such as
192.168.0.2.
6. Configure the tftpFileName variable with the current name of
the software that will be downloaded into the
AT-VP504E FXS.
You can use any name you want. However, make sure that
the name you enter matches the name of the file located on
the TFTP server.
7. Disable the AT-VP504E FXS by setting the apaCmdMode
variable to 1.
8. Initiate the image download by setting the apaCmdDownload
Software
variable to 1.
This will start the download process.