Specifications

Chapter 5 - Software Download Administration Manual (SIP/MGCP Version)
AT-VP504E FXS 46
To use static information:
1. Locate the tftpUseDhcp variable (under tftpGroup ).
This variable defines whether the AT-VP504E FXS must ask
for its TFTP server settings through a DHCP server or not.
2. Set the tftpUseDhcp variable to 0=Static.
3. Set the following variables:
Download Proce-
dure
When upgrading the software in the AT-VP504E FXS to a new protocol
or a new major revision, Allied Telesyn recommends to re-create the
file system of the AT-VP504E FXS. To do this, you must perform a
Factory Default Settings procedure. See “Factory Settings Mode” on
page 24 for more details.
To download the latest software:
1. Make sure you are trying to install the latest version of the
software.
2. Setup the TFTP server that will be used to download the
software (see “Configuring the TFTP Server” on page 43).
Table 20: TFTP Static Address
Variable Description
tftpServerStaticHost Static TFTP server IP address or
domain name.
Default Value: 192.168.0.10
tftpServerStaticPort Static TFTP server IP Port number.
Default Value: 69
tftpServerStaticEmergencyHost Static emergency TFTP server IP
address or domain name.
Default Value: 192.168.0.10
tftpServerStaticEmergencyPort Static emergency TFTP server IP Port
number.
Default Value: 514