Specifications

Chapter 2 - Installation Administration Manual (SIP/MGCP Version)
AT-VP504E FXS 23
is connected into the Ethernet connector of the AT-VP504E
FXS and the other one links the computer to the Hub.
Alternatively, you can connect a 10/100 BaseT Ethernet RJ-
45 crossover cable into the
Ethernet connector of the
AT-VP504E FXS and connect the other end to your
computer.
You must perform the recovery mode in a closed network.
You must also perform it on only one AT-VP504E FXS at a
time, since the default IP address is the same on every unit.
3. If you are using Windows, access Start/Settings/Control
Panel/Network
. In the Protocols tab, highlight the TCP/IP
protocol and click
Properties .
4. Select the network adapter you are about to assign a static IP
address to.
In the
IP address tab, choose Specify an IP address . Enter
the IP Address of
192.168.0.10 and the Subnet Mask of
255.255.255.0 . Close all the windows and reboot your
computer.
5. Insert a small paper clip into the Default Settings switch hole
of the AT-VP504E FXS. While depressing the
Default
Settings
switch, power the unit on.
The electrical outlet shall be installed near the AT-VP504E
FXS so that it is easily accessible. All three LEDs should stop
blinking, staying ON to inform you that the recovery reset has
been performed.
In recovery mode, the following default parameters are
statically assigned to the AT-VP504E FXS:
• Default local IP address: 192.168.0.1
• Default subnet mask: 255.255.255.0
All the MIB parameters except
interfaceUseDhcp are kept.
In this mode, SIP/MGCP is deactivated. Only SNMP can be
used to set any appropriate parameter value, especially the
IP address.
Note: Hold the Default Settings switch just a few seconds (less than
15 seconds).