Specifications

Chapter 2 - Installation Administration Manual (SIP/MGCP Version)

AT-VP504E FXS 15

510 mm x 12 mm (12 inches x 20 inches x 0.5 inches)

securely to the wall, if necessary.

3. Position the wall-mounting bracket against the wall (or

plywood) and ensure that one of the sides with two screw

holes faces the sides or the top (see Figure 5). Do not

position the side with two screw holes downward. Mark

the position of the screw holes on the wall. Drill the two holes.

Figure 5: Wall Mounting bracket

4. Insert suitable brackets and screws (not provided) to the wall

or plywood. Attach the wall-mounting bracket to the screws to

ensure that the bracket is secure.

5. Remove the wall-mounting bracket from the wall and place it

right side up on a hard flat surface with the front (the side that

has two screw holes) facing toward you.

6. Remove all of the rubber feet from the AT-VP504E FXS, if

applicable.

7. Place the AT-VP504E FXS right side up on the wall-mounting

bracket, with the front facing toward you.

8. Place the AT-VP504E FXS screw holes on the side over the

mounting holes of the wall bracket. See Figure 6 for the

location of the wall-mounting pieces.