Specifications

Chapter 2 - Installation Administration Manual (SIP/MGCP Version)
AT-VP504E FXS 14
The left and right mounting brackets are not identical.
Therefore, make sure that you use the proper bracket.The
bracket should be perfectly aligned with the side of the
AT-VP504E FXS.
5. Insert the two screws in the left mounting bracket, and
tighten.
6. Repeat steps 4 and 5 for the other side of the AT-VP504E
FXS.
7. Insert the AT-VP504E FXS into the bracket and secure with
suitable screws (not provided). Make sure that the ventilation
holes are not obstructed.
8. Connect the cabling as per “Connecting the AT-VP504E
FXS” on page 17.
Wall-Mounting the AT-VP504E FXS
A single AT-VP504E FXS can be wall-mounted.
To wall-mount the AT-VP504E FXS:
1. Disconnect all of the cables from the AT-VP504E FXS before
mounting.
2. Ensure that the wall you are using is smooth, flat, dry and
sturdy. Attach a piece of plywood, approximately 305 mm x
B 1 Right rack-mount bracket (already installed in Figure 4)
C 1 Left rack-mount bracket
D 4 6 x 32 5/16 across 7/64 thick steel Hex machine screw
nuts
E 4 6 x 32 UNC 1/2 steel philips binding head screws
F 4 6 bolt size split lock washers
Table 7: Rack-Mounting Pieces (Continued)
Item No. Qty. Description
Note: You must use the screws supplied with the mounting brackets.
Damage caused to the unit by using incorrect screws invalidates your
warranty.