Specifications

AT-VP504E FXS 119
A
Country Specific Parameters
The following parameters differ depending on the country you are in.
Note that the
On – Off sequence should be read as follows:
1.0 – 0.85 means that the sequence is 1.0 second On
and 0.85 second Off.
Australia The following parameters apply if you have selected Australia as
location.
Austria The following parameters apply if you have selected Austria as
location.
Table 57: Australia Parameters
Parameter Value On – Off Sequence (s) Elect. Levels
Dial Tone 425 Hz CONTINUOUS -20 dBm
Busy Tone 400 Hz 0.375 – 0.375 -13 dBm
Ringing Tone 450 Hz + 450 Hz 0.4 – 0.2 – 0.4 – 2.0 -19 dBm
Special Information Tone 950 Hz
1400 Hz
1800 Hz
0.33
0.33
0.33 – 1.0
-20 dBm
Ring 65 VRMS, 50 Hz 0.4 – 2.0
Impedance Z
R
= 220 Ω + 820 Ω // 120 nF
Tbrl-Impedance Z
N
=220 Ω + 820 Ω // 120 nF
FXS Line Attenuation (Input) 0 dBr
FXS Line Attenuation (Output) -6 dBr
Table 58: Austria Parameters
Parameter Value On – Off Sequence (s) Elect. Levels
Dial Tone 450 Hz 1.0 – 0.85 -20 dBm
Busy Tone 450 Hz 0.45 – 0.45 -13 dBm
Ringing Tone 450 Hz 1.0 – 4.0 -20 dBm
Special Information Tone 950 Hz
1400 Hz
1800 Hz
0.33
0.33
0.33 – 1.0
-20 dBm
Ring 65 VRMS, 50 Hz 1 – 5
Impedance Z
R
= 270 Ω + 750 Ω // 150 nF
Tbrl-Impedance Z
N
= 600 Ω
FXS Line Attenuation (Input) +3 dBr
FXS Line Attenuation (Output) -10 dBr