Specifications

Chapter 12 - Telephony Configuration Administration Manual (SIP/MGCP Version)
AT-VP504E FXS 95
countryGroup section of the Provisioning MIB.
Each of these Dial Map rules has seven (7) specific variables that you
must define for the Dial Map to work properly. For example, the
following are the variables associated with Dial Map #1.
Table 40: Dial Map Rules Variables
Variable Description
apaUIMapRule1
Enable
Possible Values:
• 0 = Disable
• 1 = Enable
When selecting 1, the AT-VP504E FXS will compare
the number users dial to the valid Dial Map for a match.
Keep in mind that you can have up to four (4) Dial Map
Rules active. Each of them will be compared and, if
there is a match with any of the rules, the call will be
made.
apaUIMapRule1
DialMap
Actual Dial Map string to which the number will be
compared. This Dial Map will be validated. A valid Dial
Map could be:
011x.T|011x.#|1xxxxxxxxxx|[2-8]xxxxxx
apaUIMapRule1
IsValid
Possible Values:
•0 = Not valid
• 1 = Valid
The AT-VP504E FXS will validate the Dial Map after a
SNMP set. The result (valid, invalid) is displayed.
apaUIMapRule1
RemDigitEnable
Indicates if digits are to be removed from the number
dialed by users when making the call. A complete and
valid telephone number must contain a Country Code,
an Area Code, and a number.
Possible Values:
• 0 = Disable
• 1 = Enable
apaUIMapRule1
RemDigitCount
If the
apaUIMapRule1RemDigitEnable variable is
enabled, specifies the number of digits to remove from
the number dialed by users. Digits are removed at the
beginning of the dial string.