User`s guide

AT-S41 User’s Guide
189
If the switch does not contain a port trunk, all of the ports on the
switch will be un-checked. If there is a port trunk, the ports of the
trunk will be checked.
2. To create a port trunk, do the following:
a. Check the ports that will make up the port trunk. A port trunk can
contain up to four ports. All of the ports in a port trunk must be in
the same trunk group.
b. Select Enable from the pull-down menu to the right of the trunk
group that contains the port trunk members.
c. Click the Apply button to the right of the port trunk group you
enabled.
The new port trunk is immediately activated on the switch.You
can now connect the data cables to the ports of the trunk on the
switch.
3. To delete a port trunk do the following:
a. Deselect all port members of the trunk you want to delete.
b. Select Disable from the pull-down menu to the right of the trunk
group that contained the port trunk members.
c. Click the Apply button to the right of the port trunk group you
disabled.