User`s guide

AT-S41 User’s Guide
28
Starting a Local
Management
Session
To start a local management session, perform the following procedure:
1. Connect one end of the null modem management cable included
with the switch to the RS232 Terminal Port on a master of the stack.
The master switch has a Stack ID of 1. (The STACK ID LEDs on the front
of the switches will tell you which is the master switch of the stack.)
Figure 1 Connecting a Terminal or PC to the RS232 Terminal Port
2. Connect the other end of the cable to an RS232 port on a terminal or
a PC with a terminal emulation program.
3. Configure the terminal or terminal emulation program as follows:
Emulation mode: VT100
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Key mode: Terminal keys
DE
RS232