User`s guide

156
Chapter 18
Basic Switch Parameters
The procedures in this chapter explain how to set the following switch
parameters:
❑ Configuring an IP Address on page 157
❑ Configuring System Administration Information on page 159
❑ Setting the User Interface Configuration on page 161
❑ Activating DHCP on page 163
❑ Configuring SNMP Community Strings and Trap IP Addresses
on page 164
❑ Resetting the Management Software Default Values on page
166
❑ Rebooting a Switch on page 167
❑ Viewing the AT-S41 Switch Information on page 168
❑ Ping Execution on page 169
❑ Bootstrap Configuration on page 171