User`s guide

AT-S39 Command Line Interface User’s Guide
163
SET PORTACCESS
Syntax
set portaccess port=port
[role=none|authenticator]
[control=auto|forceauthenticate|
forceunauthenticate]
[quietperiod=integer] [txperiod=integer]
[reauthperiod=integer] [supptimeout=integer]
[servtimeout=integer] [maxreq=integer]
Parameters
port Specifies the port whose port-based access control
role or settings you want to change. You can specify
more than one port at a time.
role Specifies the role of the port. The role can be one of
the following:
authenticator Specifies the Authenticator
role.
none Disables port-based access
control on the port. This is
the default setting.
control Specifies the authenticator state. This parameter can
take the following values:
auto Sets the port state to 802.1X
port-based authentication.
The port begins in the
unauthorized state, allowing
only EAPOL frames to be
sent and received through
the port. The authentication
process begins when the
link state of the port
changes. The switch
requests the identity of the
client and begins relaying
authentication messages
between the client and the
authentication server. Each
client that attempts to
access the network is