User`s guide

Chapter 18: 802.1x Port-based Access Control Commands
162
ENABLE PORTACCESS
Syntax
enable portaccess
Parameters
None.
Description
Use this command to enable 802.1x port-based access control on your
switch. When enabled, supplicant nodes must log on to pass traffic
through the switch.
Note
You should configure the RADIUS client software on the switch
before enabling port-based access control. Refer to SET
AUTHENTICATION on page 157.
Note
This command must be performed from a local management
session.
Example
The following command enables 802.1x port-based access control on
the switch:
enable portaccess