User`s guide

AT-S39 User’s Guide
31
Starting a Local
Management
Session
To start a local management session, perform the following procedure:
1. Connect one end of the straight-through RS232 management cable
with a DB-9 connector to the RS232 Terminal Port on the switch. (The
management cable is included with the switch.)
Figure 1 Connecting a Terminal or PC to the RS232 Terminal Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
❑ Baud rate: 1200 bps to 115200 bps (default 9600; see Note below)
❑ Data bits: 8
❑ Parity: None
❑ Stop bits: 1
❑ Flow control: None
DE
LINK
MODE
PORT B
FAULT
MASTER
PWR
RS-232 TERMINAL PORT