User`s guide

AT-S39 User’s Guide
295
Displaying STP or RSTP Settings
To display STP or RSTP parameter settings, perform the following
procedure:
1. From the Home page, select Monitoring.
2. From the Monitoring menu, select Layer 2.
3. From the Layer 2 page, select the Spanning Tree tab.
The Spanning Tree menu in Figure 93 is displayed. This menu
displays information on whether spanning tree is enable or
disabled and which protocol version, STP or RSTP, is active.
Figure 92 Spanning Tree Tab - Monitoring
4. To view STP or RSTP parameter settings, click either STP
Configuration or RSTP Configuration and click View.