User`s guide

Section II: Local and Telnet Management

224

❑ The file to be downloaded must be stored on the computer or

terminal connected to the RS232 Terminal Port on the switch.

Here are guidelines that apply to a TFTP download:

❑ There must be a node on your network that contains the TFTP

server software. The AT-S39 image file or configuration file to

download must be stored on the server.

❑ You should start the TFTP server software before you begin the

download procedure.

❑ The switch where you are downloading the file must have an IP

address and subnet mask. Consequently, you cannot use TFTP on

a slave switch of an enhanced stack unless the switch has an IP

address. Rather, you would need to perform the download using

Xmodem or, alternatively, switch-to-switch, as explained in

Downloading Files Switch to Switch on page 232.

To download a new software image or configuration file onto a switch

from a local management session, perform the following procedure:

1. Establish a local management session on the switch where you intend

to download the new management software or configuration file.

For instructions, refer to Starting a Local Management Session

on page 31.

2. From the Main Menu, type 4 to select Administration Menu.

3. From the Administration Menu, type D to select Downloads &

Uploads.

The Downloads and Uploads menu is shown in Figure 63:

Figure 63 Downloads & Uploads Menu

Allied Telesyn Ethernet Switch AT-8024 - AT-S39

Sales Switch

Downloads & Uploads

1 - Download Application Image/Bootloader

2 - Download Configuration Data

3 - Upload Application Image

4 - Upload Configuration Data

R -

Return to Previous Menu

Enter your selection?