User`s guide

AT-S39 User’s Guide
209
Enabling and Disabling Port Access Control
This procedure explains how to enable and disable port-based access
control on the switch. If you plan to activate the feature, there are two
things you need to do first. They are:
❑ Configure the RADIUS authentication protocol on the switch, as
explained in Configuring the Authentication Client Software
on page 196.
❑ Assign port roles and configure the parameter settings, as
explained in Configuring Port Access Control Parameters on
page 211.
To enable or disable 802.1x port-based access control, perform the
following procedure:
Note
You must use a local management session to configure port-based
access control. You cannot configure this feature through a Telnet
management session or enhanced stacking.
1. From the Main Menu, type 1 to select Port Menu.
The Port Menu is shown in Figure 12 on page 66.
2. Type 6 to select Port Access Control.
The Port Access Control menu is shown in Figure 57.
Figure 57 Port Access Control Menu
Allied Telesyn Ethernet Switch AT-8024 - AT-S39
Sales Switch
Login Privilege: Manager
Port Access Control
1 - Port Access Control .............. Enabled
2 - Authentication Method ............ RADIUS EAP
3 - Configure Port Access Parameters
4 - Display Port Access Parameters
5 - Display Port Access Status
S - Save Configuration changes
R - Return to Previous Menu
Enter your selection?