Specifications

97
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
show 802.1p default_priority
Purpose Used to display the currently configured 802.1p priority tags that will be assigned to incoming, untagged packets
before being forwarded to its destination.
Syntax show 802.1p default_priority {<portlist>}
Description The show 802.1p default_priority command displays the currently configured 802.1p priority tag that
will be assigned to an incoming, untagged packet before being forwarded to its destination.
Parameters <portlist> – Specifies a port or range of ports to be viewed.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest switch number,
and the highest port number of the range (also separated by a colon) are specified.The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in
numerical order.
Restrictions None.
Example usage:
To display the current 802.1p default priority configuration on the Switch:
AT-9724TS:4# show 802.1p default_priority
Command: show 802.1p default_priority
P o r t P r i o r i t y
- - - - - - - - - - - - -
1 : 1 0
1 : 2 0
1 : 3 0
1 : 4 0
1 : 5 0
1 : 6 0
1 : 7 0
1 : 8 0
1 : 9 0
1 : 1 0 0
1 : 1 1 0
1 : 1 2 0
1 : 1 3 0
1 : 1 4 0
1 : 1 5 0
1 : 1 6 0
1 : 1 7 0
1 : 1 8 0
1 : 1 9 0
1 : 2 0 0
1 : 2 1 0
1 : 2 2 0
1 : 2 3 0
1 : 2 4 0
A T - 9 7 2 4 T S : 4 #