Specifications

65
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
config syslog host all
Purpose Used to configure the syslog protocol to send system log data to a remote host.
Syntax show config syslog host all [severity [informational | warning | all] | facility [local0 | local1
| local2 | local3 | local4 | local5 | local6 | local7] | udp_port <int> | state [enable | disable]]
Description The config syslog host all command is used to configure the syslog protocol to send system log
information to a remote host.
Parameters all – Specifies that the command will be applied to all hosts.
severity – Severity level indicator.These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical Code Severity
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational – Specifies that informational messages will be sent to the remote host.This corresponds to
number 6 from the list above.
warning – Specifies that warning messages will be sent to the remote host.This corresponds to number 4 from
the list above.
all – Specifies that all of the currently supported syslog messages that are generated by the Switch will be sent
to the remote host.
facility – Some of the operating system daemons and processes have been assigned Facility values. Processes and
daemons that have not been explicitly assigned a Facility may use any of the "local use" facilities or they may use
the "user-level" Facility.Those Facilities that have been designated are shown in the following:
Bold font indicates the facility values the Switch currently supports.
Numerical Code Facility
0 kernel messages
1 user-level messages
2 mail system
3 system daemons
4 security/authorization messages
5 messages generated internally by syslog
6 line printer subsystem
7 network news subsystem
8 UUCP subsystem
9 clock daemon
10 security/authorization messages
11 FTP daemon
12 NTP subsystem
13 log audit
14 log alert
15 clock daemon
16 local use 0 (local0)
17 local use 1 (local1)
18 local use 2 (local2)
19 local use 3 (local3)
20 local use 4 (local4)
21 local use 5 (local5)
22 local use 6 (local6)
23 local use 7 (local7)