Specifications

config ospf all
Purpose Used to configure all of the OSPF interfaces on the Switch at one time.
Syntax config ospf all {area <area_id> | priority <value> | hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | authentication [none | simple <password 8> | md5 <key_id
1-255>] | metric <value 1-65535> | state [enable | disable]}
Description This command is used to configure all of the OSPF interfaces on the Switch, using a single group of parameters,
at one time.
Parameters area <area_id> – A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the
OSPF area in the OSPF domain.
priority <value> – The priority used in the election of the Designated Router (DR).A number between 0 and
255.
hello_interval <sec 1-65535> – Allows the specification of the interval between the transmission of OSPF Hello
packets, in seconds. Between 1 and 65535 seconds can be specified.The Hello Interval, Dead Interval,
Authorization Type, and Authorization Key should be the same for all routers on the same network.
dead_interval <sec 1-65535> – Allows the specification of the length of time between the receipt of Hello
packets from a neighbor router before the selected area declares that router down.An interval between 1 and
65535 seconds can be specified.The Dead Interval must be evenly divisible by the Hello Interval.
metric <value 1-65535 > – The interface metric (1 to 65535). Entering a 0 will allow automatic calculation of the
metric.
authentication – Enter the type of authentication preferred.The user may choose between:
none – Choosing this parameter will require no authentication.
simple <password 8> – Choosing this parameter will set a simple authentication which includes a
case-sensitive password of no more than 8 characters.
md5 <key_id 1-255> – Choosing this parameter will set authentication based on md5 encryption.
A previously configured MD5 key ID (1 to 255) is required.
metric <value 1-65535> – This field allows the entry of a number between 1 and 65,535 that is representative of
the OSPF cost of reaching the selected OSPF interface.The default metric is 1.
state [enable | disable] – Used to enable or disable this function.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure all of the OSPF interfaces on the Switch with a single group of parameters:
AT-9724TS:4# config ospf all state enable
Command: config ospf all state enable
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
262
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual