Specifications

config ospf aggregation
Purpose Used to configure the OSPF area aggregation settings.
Syntax config ospf aggregation <area_id> <network_address> lsdb_type summary {advertise
[enable | disable]}
Description This command is used to configure the OSPF area aggregation settings.
Parameters <area_id> – A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF
area in the OSPF domain.
<network_address> – The 32-bit number in the form of an IP address that uniquely identifies the network that
corresponds to the OSPF Area.
lsdb_type summary – Specifies the type of address aggregation.
advertise {enable | disable} – Allows for the advertisement trigger to be enabled or disabled.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the OSPF area aggregation settings:
AT-9724TS:4# config ospf aggregation 10.1.1.1
10.48.76.122/16 lsdb_type summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show ospf aggregation
Purpose Used to display the current OSPF area aggregation settings.
Syntax show ospf aggregation {<area_id>}
Description This command will display the current OSPF area aggregation settings.
Parameters <area_id> – Enter this parameter to view this table by a specific OSPF area ID.
Restrictions None.
Example usage:
To display OSPF area aggregation settings:
AT-9724TS:4# show ospf aggregation
Command: show ospf aggregation
OSPF Area Aggregation Settings
Area ID A g g r e g a t e d L S D B A d v e r t i s e
Network Address T y p e
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 0 . 1 . 1 . 1 1 0 . 0 . 0 . 0 / 8 S u m m a r y E n a b l e d
1 0 . 1 . 1 . 1 2 0 . 2 . 0 . 0 / 1 6 S u m m a r y E n a b l e d
Total Entries: 2
A T - 9 7 2 4 T S : 4 #
258
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual