Specifications

configure ospf area
Purpose Used to configure OSPF’s area settings.
Syntax config ospf area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
Description This command is used to configure an OSPF area’s settings.
Parameters <area_id> – The OSPF area ID.The user may enter a 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain.
type [normal | stub] – Allows the specification of the OSPF mode of operation – stub or normal.
stub_summary [enable | disable] – Allows the OSPF area import of LSA advertisements to be enabled or
disabled.
metric <value 0-65535> – The OSPF area stub default cost.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure an OSPF area’s settings:
AT-9724TS:4# config ospf area 10.48.74.122 type stub
stub_summary enable metric 1
Command: config ospf area 10.48.74.122 type stub
stub_summary enable metric 1
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show ospf area
Purpose Used to display an OSPF area’s configuration.
Syntax show ospf area {<area_id>}
Description This command will display the current OSPF area configuration.
Parameters <area_id> – A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF
area in the OSPF domain.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display an OSPF area’s settings:
AT-9724TS:4# display ospf area
Command: display ospf area
Area Id T y p e Stub Import Summary LSA S t u b Default Cost
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
0 . 0 . 0 . 0 N o r m a l N o n e N o n e N o n e
1 0 . 4 8 . 7 4 . 1 2 2 S t u b E n a b l e d E n a b l e d 1
Total Entries : 2
A T - 9 7 2 4 T S : 4 #
254
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual