Specifications

OSPF Area Aggregation Settings
Area ID A g g r e g a t e d L S D B A d v e r t i s e
Network Address T y p e
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Total Entries : 0
OSPF Host Route Settings
Host Address M e t r i c Area ID
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 0 . 3 . 3 . 3 1 1 0 . 1 . 1 . 1
Total Entries : 1
A T - 9 7 2 4 T S : 4 #
create ospf area
Purpose Used to configure OSPF area settings.
Syntax create ospf area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
Description This command is used to create an OSPF area and configure its settings.
Parameters <area_id> – The OSPF area ID.The user may enter a 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain.
type [normal | stub] – The OSPF area mode of operation – stub or normal.
stub_summary [enable | disable] – Enables or disables the OSPF area to import summary LSA advertisements.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create an OSPF area:
AT-9724TS:4# create ospf area 10.48.74.122 type normal
Command: create ospf area 10.48.74.122 type normal
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
delete ospf area
Purpose Used to delete an OSPF area.
Syntax delete ospf area <area_id>
Description This command is used to delete an OSPF area.
Parameters <area_id> – A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF
area in the OSPF domain.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete an OSPF area:
AT-9724TS:4# delete ospf area 10.48.74.122
Command: delete ospf area 10.48.74.122
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
253
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual