Specifications

create route redistribute dst rip src
Purpose Used to add route redistribution settings for the exchange of OSPF routes to RIP routes on the Switch.
Syntax create route redistribute dst rip src {all | internal | external | type_1 | type_2 | inter+e1 |
inter+e2}] {metric <value>}
Description This command will redistribute routing information between the OSPF and RIP routing protocols to all routers
on the network that are running OSPF or RIP. Routing information entered into the Static Routing Table on the
local AT-9724TS switch is also redistributed.
Parameters src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} – Allows the selection of the protocol of the
source device.The user may choose between:
all – Specifies both internal an external.
internal – Specifies the internal protocol of the source device.
external – Specifies the external protocol of the source device.
type_1 – Calculates the metric (for RIP to OSPF) by adding the destination’s interface cost to the
metric entered in the Metric field.
type_2 – Uses the metric entered in the Metric field without change.This field applies only when the
destination field is OSPF.
inter+e1 – Specifies the internal protocol AND type 1 of the external protocol.
inter+e2 – Specifies the internal protocol AND type 2 of the external protocol.
mettype [1 | 2] – Allows for the selection of one of two methods of calculating the metric value.
metric <value > – Allows the entry of an OSPF interface cost.This is analogous to a Hop Count in the RIP
routing protocol.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the contents of the IP routing table:
AT-9724TS:4# show iproute
Command: show iproute
IP Address/Netmask G a t e w a y I n t e r f a c e C o s t P r o t o c o l
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
0 . 0 . 0 . 0 1 0 . 1 . 1 . 2 5 4 S y s t e m 1 D e f a u l t
1 0 . 0 . 0 . 0 / 8 1 0 . 4 8 . 7 4 . 1 2 2 S y s t e m 1 L o c a l
Total Entries: 2
A T - 9 7 2 4 T S : 4 #
Routing information source – OSPF and the Static Route table. Routing information will be redistributed to RIP.The following table lists the allowed values for the
routing metrics and the types (or forms) of the routing information that will be redistributed.
Route Source Metric Metric Type
OSPF 0 to 16 all
type_1
inter+e1
inter+e2
internal
Static 0 to 16 not applicable
Entering the Type combination – internal type_1 type_2 is functionally equivalent to all. Entering the combination type_1 type_2 is functionally
equivalent to external. Entering the combination internal external is functionally equivalent to all.
Entering the metric 0 specifies transparency.
225
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual