Specifications

show sim
Purpose Used to view the current information regarding the SIM group on the Switch.
Syntax show sim {[candidates {<candidate_id 1-100>} | members {<member_id 1-32>} | group
{commander_mac <macaddr>} neighbor]}
Description This command will display the current information regarding the SIM group on the Switch, including the
following:
SIM Version – Displays the current Single IP Management version on the Switch.
Firmware Version – Displays the current Firmware version on the Switch.
Device Name - Displays the user-defined device name on the Switch.
MAC Address - Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer 3 (L3).
Platform – Switch Description including name and model number.
SIM State –Displays the current Single IP Management State of the Switch, whether it be enabled or disabled.
Role State – Displays the current role the Switch is taking, including Commander, Member or Candidate.A
stand-alone switch will always have the candidate role.
Discovery Interval – Time in seconds the Switch will send discovery packets out over the network.
Hold time – Displays the time in seconds the Switch will hold discovery results before dropping it or utilizing it.
Parameters candidates <candidate_id 1-100> – Entering this parameter will display information concerning candidates of the
SIM group.To view a specific candidate, include that candidate’s ID number, listed from 1 to 100.
members <members_id 1-32> – Entering this parameter will display information concerning members of the SIM
group.To view a specific member, include that member’s ID number, listed from 1 to 32.
group commander_mac <macaddr> – Entering this parameter will display information concerning the SIM group
of a commander device,.identified by its MAC address.
neighbor – Entering this parameter will display neighboring devices of the Switch.A SIM neighbour is defined as
a switch that is physically connected to the Switch but is not part of the SIM group.This screen will produce the
following results:
Port – Displays the physical port number of the commander switch where the uplink to the
neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor switch.
Role – Displays the role (CS, CaS, MS) of the neighbor switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To show the SIM information in detail:
AT-9724TS:4# show sim
Command: show sim
SIM Version : VER-1
Firmware Version : Build 3.00-B16
Device Name :
MAC Address : 00-35-26-11-11-00
C a p a b i l i t i e s : L3
P l a t f o r m : AT-9724TS L3 Switch
SIM State : Enabled
Role State : Commander
Discovery Interval : 30 sec
Hold Time : 100 sec
A T - 9 7 2 4 T S : 4 #
198
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual