Specifications

show auth_statistics
Purpose Used to display the current authentication statistics.
Syntax show auth_statistics {ports [<portlist>}
Description The show auth_statistics command is used to display the current authentication statistics of the Switch on
a per port basis.
Parameters ports <portlist> – Specifies a range of ports.The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.Then the highest switch number, and the highest
port number of the range (also separated by a colon) are specified.The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2,port 4 – in numerical order.
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
To display the current authentication statistics for port 16:
AT-9724TS:4# show auth_statistics ports 1:16
Command: show auth_statistics ports 1:16
Port number: 1 : 1 6
E a p o l F r a m e s R x 0
E a p o l F r a m e s T x 0
E a p o l S t a r t F r a m e s R x 0
E a p o l R e q l d F r a m e s T x 0
E a p o l L o g O f f F r a m e s R x 0
E a p o l R e q F r a m e s T x 0
E a p o l R e s p l d F r a m e s R x 0
E a p o l R e s p F r a m e s T x 0
I n v a l i d E a p o l F r a m e s R x 0
E a p o l L e n g t h E r r o r F r a m e s R x 0
L a s t E a p o l F r a m e V e r s i o n 0
L a s t E a p o l F r a m e S o u r c e 0 0 - 0 0 - 0 0 - 0 0 - 0 0 - 0 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
184
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual