Specifications

config 802.1x reauth ports
Purpose Used to configure the 802.1x re-authentication feature of the Switch.
Syntax config 802.1x reauth [port_based ports [<portlist | all>] | mac_based [ports] [<portlist> |
all] {mac_address <macaddr}]
Description The config 802.1x reauth command is used to re-authenticate a previously authenticated device based on
port number or MAC address.
Parameters port_based – This instructs the Switch to initialize 802.1x functions based only on the port number. Ports
approved for re-authorization can then be specified.
ports <portlist> – Specifies a range of ports.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest
switch number, and the highest port number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 – in numerical order.
all – Specifies all of the ports on the Switch
mac_based – This instructs the Switch to re-authorize 802.1x functions based on a specific MAC address. Ports
approved for re-authorization can then be specified.
<portlist> – Specifies a range of ports.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest
switch number, and the highest port number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 – in numerical order.
all – Specifies all of the ports on the Switch
mac_address<macaddr> – Specifies the MAC address of the client the user wishes to add.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x reauthentication for ports 1-18:
AT-9724TS:4# config 802.1x reauth port_based ports 1:1-1:18
Command: config 802.1x reauth port_based ports 1:1-1:18
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
177
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual