Specifications

max_req <value 1-10> – Configures the number of times to retry sending packets to a supplicant (user).
reauth_period <sec 1-65535> – Configures the time interval between successive re-authentications.
enable_reauth [enable | disable] – Determines whether or not the Switch will re-authenticate. Enabled causes re-
authentication of users at the time interval specified in the Re-authentication Period field, above.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:
AT-9724TS:4# config 802.1x auth_parameter ports 1:1–1:20
direction both
Command: config 802.1x auth_parameter ports 1:1–1:20
direction both
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
config 802.1x auth_protocol
Purpose Used to configure the 802.1x authentication protocol on the Switch.
Syntax config 802.1x auth_protocol [local | radius_eap]
Description The config 802.1x auth_protocol command enables you to configure the authentication protocol.
Parameters [local | radius_eap] – Specify the type of authentication protocol desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the authentication protocol on the Switch:
AT-9724TS:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
175
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual