Specifications

Example usage:
To display the 802.1x auth state for MAC-based 802.1x::
AT-9724TS:4#show 802.1x auth_state
Command: show 802.1x auth_state
Port number : 1:1
I n d e x MAC Address Auth PAE State Backend State Port Status
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 0 0 - 0 8 - 0 2 - 4 E - D A - F A A u t h e n t i c a t e d I d l e A u t h o r i z e d
2
3
4
6
7
9
1 0
1 2
1 3
1 4
1 5
1 6
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
config 802.1x auth_mode
Purpose Used to configure the 802.1x authentication mode on the Switch.
Syntax config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x authentication mode command is used to enable either the port-based or MAC-based
802.1x authentication feature on the Switch.
Parameters [port_based | mac_based ports] – The Switch allows you to authenticate 802.1x by either port or MAC address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication by MAC address:
AT-9724TS:4# config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
173
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual